Installing Garage Doors Made Easy with these 3 Basic Steps

Installing a garage door is feasible if you will understand the basics to complete the whole process. In fact, anyone can do it within a few hours. To get you all the details in understanding the basics of garage door installations is what this article will help you with. To complete it, you will need tools, help and time. The following are the 3 basic steps that needs to be understood first before you start the installation process.

Preparation Phase. The whole process on your manufacturer’s manual must be reviewed first before even starting the work. You will be able to anticipate what step is coming next and tools you are going to need by reading the manual. Remember, the instructions on the manual supersede any other guides. After reviewing the manual, make an inventory of all the parts you are going to need. Usually all the parts are listed in the manual. To organize the parts into piles for easier process is highly suggested. All the tools and materials you are going to need must be prepared, including a ladder. The first panel must be prepared before installing it. You can leave the hinges on left and right into the roller.

Installation Phase. It is important that the first panel must be able to cover the opening. Most standard garage doors are about 7 feet high and 9 feet wide. All of these, curved parts, vertical and horizontal of the track, are separated and attached in separate steps. Using slide rollers onto end of the track of the first panel, the vertical track is recommended to be installed first. Be sure to lower it in place. Tracks are installed in the center of the opening. All the way until the next panel, the brackets must be tightened. Durham Garage Door Installation experts suggest that to install the second panel, it is best to get help because the outside hinges must be attached first before the panel can be put in place. Both are subsequently installed, the hinges and rollers. Don’t forget about pre-drilling the holes before you install the second one. The vertical track is plumb, the door level, and the track up the wall must be secured. The torque tube and curved tracks is advised to be installed by a professional to avoid repeating the whole process.
Finding Ways To Keep Up With Garages

Post-Installation Phase. Clean the area first before trying the door for the first time. Once you are satisfied with the alignment of tracks, tighten the fasteners. Finally, check the operation of the door working up and down.
A Beginners Guide To Doors

Understanding these 3 basic steps will surely help you complete a garage door installation successfully.